Automated Logic S6104 Instrucciones técnicas - Página 15
Navegue en línea o descargue pdf Instrucciones técnicas para Unidad de control Automated Logic S6104. Automated Logic S6104 16 páginas.
Imprimir página- 1. Table of Contents
- 2. Using the S6104
- 3. Specifications
- 4. Mounting
- 5. Addressing
- 6. Power Wiring
- 7. Network Communications
- 7. Using the S6104 on an ARC156 Segment
- 7. Using the S6104 on a Legacy Cmnet
- 7. Connecting the S6104 to the Network
- 7. Communicating through the Logistat Port Using Supervision
- 7. Communicating through the Access Port Using Supervision
- 8. Inputs
- 8. Logistat Wiring
action pane. To retry a failed download,
click the module in the Failures list, click
Add, and click the Execute Download
button again. If you do not want to retry a
failed download, click the Clear Failures
button.
NOTE Since a failed download indicates
a system problem, you should never clear
a failure. Locate and resolve the problem,
then retry the download.
6. Click the Properties button to refresh the
screen. This removes the items from the
Download Items list.
Transferring Memory in SuperVision
If you are using SuperVision to transfer
memory, you must use SuperVision v2.6b or
later, FB Link v2.7a or later, and the SLM
module driver. The S6104 module using the
SLM module driver can store a single FB.
1. Log in to SuperVision on a workstation
connected to the CMnet. You can also
connect directly to the module using the
Access Port or LogiStat Port; see
"Communicating with the Workstation
Using SuperVision" on page 6.
2. Navigate to the module driver and look at
the module status report in SuperVision to
make sure the module type and number
agree with the module.
• To view the module status report in
SuperVision v3.0, click Tools -
Troubleshooting - Module Status.
• To view the module status report in
SuperVision v2.6b or later, press the
[ESC} key, type
MO ,,module address,15
and press Enter.
3. Transfer memory to the module.
• In SuperVision v3.0, click Tools -
Troubleshooting - Transfer Memory to
Module.
Revised 7/30/02 • S6104
• In SuperVision v2.6b, download
memory for This Module.
4. When the memory transfer is finished,
check the module status report again.
Make sure the FB List on this page shows
the FB you intended to transfer.
Troubleshooting
Formatting the Module
If you are unable to communicate with a
module after transferring memory, you can,
as a last resort, manually format the module
to try to restore communication. Formatting
the module erases all memory, so you need to
transfer memory back to the module once it is
formatted.
NOTE Since the module is automatically
formatted when you transfer memory, you
should only manually format the module if
communication was not established after the
memory transfer.
1. Turn the module's power off. Make sure
the address switches are not set to '0 0'.
2. Press and hold the Format button (see
Figure 1 on page 2 for location). While
continuing to hold the Format button, turn
the module's power on.
3. Continue to hold the button until the Error
LED flashes three times in sync with the
Run LED.
4. Release the Format button.
5. Transfer memory to the module. Refer to
"Transferring Memory" on page 14.
LEDs
The S6104 module has several LED indicators
to show the status of certain functions.
Table 9 on page 16 explains the Run and Error
LED signals in detail to assist troubleshooting.
See Figure 17 for location of LED signals.
15
© 2002 Automated Logic Corporation