HID Aero X1100 Manual de instalación - Página 2

Navegue en línea o descargue pdf Manual de instalación para Controlador HID Aero X1100. HID Aero X1100 8 páginas. Intelligent controller

Imprimir página

Powering

Trusted Identities

Setting the jumpers

1. If attached, unscrew the four corner casing screws.

2. Remove the X1100 casing to access the battery

jumper and the end of line termination jumpers.

3. Set the battery jumper J4 to ON.

4. Set IO Module Port 1 and 2 end of line termination

jumpers J5 and J9 to IN, only if the X1100 will be the

end of communication bus.

5. Replace the casing and secure with the supplied

four corner casing screws.

Note: The static RAM and the real time clock are

backed up by a lithium battery when input power is

removed. This battery should be replaced annually.

Mounting the X1100

ATTENTION

Observe precautions for handling

ELECTROSTATIC SENSITIVE DEVICES

Always mount the controllers and interface panels

in a secure area.

Mount using the supplied screws 0.138" × 1"

(3.5 mm × 25 mm).

Alternatively mount on a DIN rail using compatible

DIN rail mounting brackets and screws.

See Recommended parts.

Note: The side terminal connectors must be

removed to fit the mounting brackets.

Communication wiring

Connect the X1100 to additional IO modules using

2-wire RS-485 IO Module ports 1 and 2. Use 1-twisted

pair, shielded cable, 120Ω impedance, 24 AWG, 4,000 ft.

(1,219 m) maximum.

Each port can support up to 32 (Aero) or 16 (VertX)

IO modules.

Note: Install RS-485 termination jumpers on the

interface boards at each end of the communication

bus only (see step 1 above). Failure to do so

will compromise the proper operation of the

communication channel.

Network connection

The X1100 controller communicates to the host via the

on-board Ethernet 10-BaseT/100Base-TX port.

HID Aero™ X1100 Installation Guide

Battery jumper J4

Termination jumper J9

Termination jumper J5

IO MODULE PORT 1 or IO MODULE PORT 2

To other

devices

on the

bus

Ethernet 10-BaseT/

100-TX port

To other

devices

on the

bus

PLT-04233, Rev. A.3