9g Products INPRINT-MICRO Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Controladores de acceso IP 9g Products INPRINT-MICRO. 9g Products INPRINT-MICRO 12 páginas.
Imprimir página
When the enrollment process is complete,
the solid GREEN light will blink. This indi-
cates the fingerprint was accepted.
Use this same procedure to enroll all fin-
gerprints (up to 15). After 15 fingerprints
have been saved, the next fingerprint
enrolled will replace the oldest saved
fingerprint. You may add fingerprints or
erase all saved fingerprints and start over
at any time.
6
STEP
Place finger on fingerprint sensor as seen
in Ref Fig. 6 above to "wake-up" the
sensor. After YELLOW light appears, slide
the finger that you have enrolled across
the fingerprint sensor exactly as it was
enrolled and slide as shown Ref Fig. 6
The INPRINT-MICRO will scan the finger
and compare it to stored fingerprints.
When a match occurs the door will open
quickly.
INSTRUCTIONAL VIDEOS AVAILABLE AT:
video.inprintsecurity.com
LIGHT INDICATIONS:
Red/Yellow/Green
Simultaneous Flash:
Memory cleared successfully.
Red Solid:
INPRINT-MICRO needs you to
reswipe your finger.
Red Continuous Slow
Flashing:
INPRINT-MICRO 's battery is low and
requires changing.
Red Rapid Flashing:
Function you are trying to perform
has timed out. Try again.
Yellow:
INPRINT-MICRO is asking for a fin-
gerprint swipe.
Green:
INPRINT-MICRO has A/C power.
7
fig .6