9g Products INPRINT-MICRO Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Controllori di accesso IP 9g Products INPRINT-MICRO. 9g Products INPRINT-MICRO 12.

When the enrollment process is complete,

the solid GREEN light will blink. This indi-

cates the fingerprint was accepted.

Use this same procedure to enroll all fin-

gerprints (up to 15). After 15 fingerprints

have been saved, the next fingerprint

enrolled will replace the oldest saved

fingerprint. You may add fingerprints or

erase all saved fingerprints and start over

at any time.

STEP

Place finger on fingerprint sensor as seen

in Ref Fig. 6 above to "wake-up" the

sensor. After YELLOW light appears, slide

the finger that you have enrolled across

the fingerprint sensor exactly as it was

enrolled and slide as shown Ref Fig. 6

The INPRINT-MICRO will scan the finger

and compare it to stored fingerprints.

When a match occurs the door will open

quickly.

INSTRUCTIONAL VIDEOS AVAILABLE AT:

video.inprintsecurity.com

LIGHT INDICATIONS:

Red/Yellow/Green

Simultaneous Flash:

Memory cleared successfully.

Red Solid:

INPRINT-MICRO needs you to

reswipe your finger.

Red Continuous Slow

Flashing:

INPRINT-MICRO 's battery is low and

requires changing.

Red Rapid Flashing:

Function you are trying to perform

has timed out. Try again.

Yellow:

INPRINT-MICRO is asking for a fin-

gerprint swipe.

Green:

INPRINT-MICRO has A/C power.

fig .6