9g Products INPRINT-MICRO Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Controllori di accesso IP 9g Products INPRINT-MICRO. 9g Products INPRINT-MICRO 12.

STEP

A/C Power: Using the A/C power supply adapter

allows the sensor to skip the waking process that

is necessary when utilizing backup battery power

only. Connect the A/C power supply adapter to

the A/C jack on the right side of the INPRINT-

MICRO and plug the A/C power supply adapter

into an electrical outlet.

STEP

The enrollment process is extremely

important. Please take your time and

become familiar with this process.

To begin the enrollment process, locate the

Administration Button above the 9g label (Ref

Fig 3). This is the same button used to erase the

memory in the last step but rather than holding the

button you will press and release it.

Press the button once using the included straight

tool or paperclip. (Do not hold the button down)

This will cause the GREEN light to appear solid

indicating it is ready to enroll. During enrollment,

the YELLOW light indicates you should swipe your

finger. Swiping should be done with the finger as

flat as possible, centered on the sensor. (Fig 4)

Start with the first joint of the finger and using an

even, moderate speed pull the finger across the

sensor. The INPRINT-MICRO will ask you to swipe

the same finger at least five times in order to

successfully enroll. If a RED light comes on during

the process it indicates the previous scan was

not successful. Do not restart the process, just

continue to swipe when the YELLOW light

comes on.

TIP: Finger must be FLAT on sensor

fig .3

fig .4

and pressed FIRMLY during swipe.