9g Products INPRINT-MICRO Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Controllori di accesso IP 9g Products INPRINT-MICRO. 9g Products INPRINT-MICRO 12.

STEP

The battery is installed inside the INPRINT-

MICRO. Remove screw and battery cover

Ref Fig 2. Attach battery to hookups

and place battery inside the compartment.

Replace door and screw in place.

Change the battery when the RED light

flashes slowly at the end of an operation

indicating that battery power is low, or if you

notice the opening process slowing.

STEP

The INPRINT-MICRO incorporates an

Administration Button located above the 9g

label (Ref Fig 3). Remove the screw with

your fingers (you do NOT need to tighten,

just finger tighten screw to close hole after

use). Use the included straight tool (or

paperclip) to insert and press Administration

Button.

1) Press and hold to clear all

memory

2) Press and release to initiate

enrollment process

To clear the INPRINT-MICRO of all

stored fingerprints, locate the

Administration Button. Press and hold

the button firmly until the RED, YELLOW

and GREEN lights rapidly flash together.

This indicates that the memory has been

completely cleared and all fingerprints

are erased. If the INPRINT-MICRO door

is now shut without an enrolled fingerprint,

the only access is with the backup keys.

CAUTION: If the Administration Button is

pushed and released, the INPRINT-MICRO

will begin an enrollment sequence rather

than clearing the memory. The GREEN

and YELLOW lights will come on for a few

seconds and then go out and the RED

light will flash rapidly indicating that the

enrollment sequence has failed. Wait until

the lights stop, then repeat the procedure

above to clear the memory.

fig .2

fig .3