Avantco Equipment DC1800 Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Gamas Avantco Equipment DC1800. Avantco Equipment DC1800 6 páginas. 1800 watt drop-in induction range
Imprimir página
Functionality & Purpose
Examples of Usable Pans
Steel or cast iron, enameled iron, stainless steel, flat-bottom pans / pots with diameter from 4 ¾ inches to 10 ¼ inches.
Examples of Non-Usable Pans
Heat-resistant glass, ceramic, copper, aluminum pans/pots. Rounded-bottom pans/pots with bottom measuring less
than 4 ¾ inches.
WARNING!
DO NOT TOUCH COOKWARE, HEATING SURFACE, FOOD, OR LIQUID
WHILE THE UNIT IS IN OPERATION!
WARNING!
ALWAYS MAKE SURE THAT THE UNIT IS OUT OF REACH FOR CHILDREN!
Before First Use
• Remove all packaging components and make sure that the appliance was not damaged during shipping.
• Before using for the first time clean the unit surface with a slightly moist cloth and dry
(see "Cleaning and Maintenance").
Installation
•
Place the unit on a flat, heat resistant surface.
•
The unit is NOT designed to be enclosed or built into an area.
•
There must be ¾" (2 cm) of space between the bottom of the unit and any surrounding surface.
•
DO NOT BLOCK THE AIRFLOW OF THE UNIT!
There must be a minimum of 4" (10 cm) between the induction range and any surrounding surface to allow
sufficient airflow around the unit. Blocking the airflow will potentially overheat the unit.
COUNTERTOP
1. Place the unit on a flat, heat resistant surface.
2. Plug the power cord into a grounded electrical outlet with the appropriate voltage level. Make sure that the unit is
the only appliance plugged into the electrical outlet.
Incorrect voltage levels will damage the unit. Incorrect voltage, modification to the power cord or electrical
components will void the warranty.
DROP-IN
1. Choose a flat, heat resistant countertop for the mounting surface.
2. Measure the area of the cutout, including the countersink area.
The depth of the surface around the cutout must be reduced to allow for the countersink.
NOTE
Exposed wood or particle board edges must be sealed with an appropriate waterproofing material.
Seal the edge between the glass and the countertop with silicone or similar material. Failure to do so
may result in damage to the countertop.
3. Seal the joint between the induction warmer and countertop.
4. Plug the power cord into a grounded electrical outlet with the appropriate voltage level listed on the unit.
www.AvantcoEquipment.com
User Manual
3