CORNING EDGE Manual - Página 7

Navegue en línea o descargue pdf Manual para Bastidores y soportes CORNING EDGE. CORNING EDGE 11 páginas. Single-module housing
También para CORNING EDGE: Instalación (4 páginas)

Imprimir página

Step 8:

Pass the supporting tie wires or

threaded rods through the mounting

brackets (Figure 11). If using wire,

simply pass the wire through the hole

in the mounting bracket, loop back up,

and make several wraps around the

wire.

Step 9:

Adjust the tension by bending the wire

with a pair of pliers. It is important not to

allow the suspended ceiling stringers to

bear the weight of the FZB.

NOTE:

If using threaded rods, it may be necessary to

adjust the top or bottom supporting bolts/nuts.

Step 10: Ensure the FZB is level and offset

slightly from the stringers or cross-

members so that the FZB is only

slightly resting on the suspending

ceiling.

Step 11:

Reinstall the ceiling panels / tiles to

complete the installation (Figure 12).

Ensure that the door is properly closed

and locked to prevent unauthorized

access and harm from the door

swinging down.

STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 7 OF 11

Figure 11

Figure 12