Brother PT-MT Manual de servicio - Página 34

Navegue en línea o descargue pdf Manual de servicio para Etiquetadora Brother PT-MT. Brother PT-MT 45 páginas.
También para Brother PT-MT: Lista de referencia de piezas (14 páginas)

Imprimir página
Brother PT-MT Manual de servicio
[ 7 ]
Inspection Mode
According to the procedure given below, place the PT-MT in the inspection mode and
make final operational checks.
In the inspection mode, you use four submodes--INFO, DIAL, CUT, and PRINT1
submodes.
TIP: The inspection mode actually supports a total of nine submodes for checking at the
factory. If any submode other than the above four is initiated, skip it by rotating the select
dial to any of Dial positions 1 to 4 to proceed to the INFO, KEY, CUT, or PRINT1
submode, respectively. Then press the Enter key.
(1) Check that the PT-MT is turned off.
(2) Set the select dial to Dial position
(3) While holding down the Print key, press the Function key ("f").
The machine enters the inspection mode and shows the following on the LCD:
NOTE: If the following message appears and the machine automatically turns itself
off, then check the solder points on the main PCB. Some solder points may be
incorrectly soldered.
.
III - 19