Brother PT-MT Servis Kılavuzu - Sayfa 34

Etiket makinesi Brother PT-MT için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Brother PT-MT 45 sayfaları.
Ayrıca Brother PT-MT için: Parça Referans Listesi (14 sayfalar)

Sayfayı Yazdır
Brother PT-MT Servis Kılavuzu
[ 7 ]
Inspection Mode
According to the procedure given below, place the PT-MT in the inspection mode and
make final operational checks.
In the inspection mode, you use four submodes--INFO, DIAL, CUT, and PRINT1
submodes.
TIP: The inspection mode actually supports a total of nine submodes for checking at the
factory. If any submode other than the above four is initiated, skip it by rotating the select
dial to any of Dial positions 1 to 4 to proceed to the INFO, KEY, CUT, or PRINT1
submode, respectively. Then press the Enter key.
(1) Check that the PT-MT is turned off.
(2) Set the select dial to Dial position
(3) While holding down the Print key, press the Function key ("f").
The machine enters the inspection mode and shows the following on the LCD:
NOTE: If the following message appears and the machine automatically turns itself
off, then check the solder points on the main PCB. Some solder points may be
incorrectly soldered.
.
III - 19