Brother PT-MT 서비스 매뉴얼 - 페이지 34

{카테고리_이름} Brother PT-MT에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-MT 45 페이지.
Brother PT-MT에 대해서도 마찬가지입니다: 부품 참조 목록 (14 페이지)

[ 7 ]

Inspection Mode

According to the procedure given below, place the PT-MT in the inspection mode and

make final operational checks.

In the inspection mode, you use four submodes--INFO, DIAL, CUT, and PRINT1

submodes.

TIP: The inspection mode actually supports a total of nine submodes for checking at the

factory. If any submode other than the above four is initiated, skip it by rotating the select

dial to any of Dial positions 1 to 4 to proceed to the INFO, KEY, CUT, or PRINT1

submode, respectively. Then press the Enter key.

(1) Check that the PT-MT is turned off.

(2) Set the select dial to Dial position

(3) While holding down the Print key, press the Function key ("f").

The machine enters the inspection mode and shows the following on the LCD:

NOTE: If the following message appears and the machine automatically turns itself

off, then check the solder points on the main PCB. Some solder points may be

incorrectly soldered.

III - 19