Fujitsu PRIMERGY TX100 S1 Manual del suplemento de servicio - Página 35
Navegue en línea o descargue pdf Manual del suplemento de servicio para Placa base Fujitsu PRIMERGY TX100 S1. Fujitsu PRIMERGY TX100 S1 46 páginas. For tx100 s1
También para Fujitsu PRIMERGY TX100 S1: Especificaciones (13 páginas), Manual de opciones (46 páginas), Manual técnico (32 páginas)
Imprimir página
Replacement routines
4.7
Replacing the processor
V
CAUTION!
Processors are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a
processor has been removed from its protective sleeve or from its socket,
place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.
Ê Open the server, and remove the air duct as described in
ration" on page
Figure 20: Removing heat sink
Ê Loosen the four screws in a crossover pattern.
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
TX100 S1
17.
Service Supplement
Replacing the processor
section "Prepa-
35