Fujitsu PRIMERGY TX100 S1 Panduan Suplemen Servis - Halaman 35
Jelajahi secara online atau unduh pdf Panduan Suplemen Servis untuk Motherboard Fujitsu PRIMERGY TX100 S1. Fujitsu PRIMERGY TX100 S1 46 halaman. For tx100 s1
Juga untuk Fujitsu PRIMERGY TX100 S1: Spesifikasi (13 halaman), Manual Opsi (46 halaman), Panduan Teknis (32 halaman)
Halaman Cetak
Replacement routines
4.7
Replacing the processor
V
CAUTION!
Processors are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a
processor has been removed from its protective sleeve or from its socket,
place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.
Ê Open the server, and remove the air duct as described in
ration" on page
Figure 20: Removing heat sink
Ê Loosen the four screws in a crossover pattern.
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
TX100 S1
17.
Service Supplement
Replacing the processor
section "Prepa-
35