CPC SS-100 Manual de instalación y programación - Página 9

Navegue en línea o descargue pdf Manual de instalación y programación para Servidor CPC SS-100. CPC SS-100 13 páginas. Serial server

Imprimir página
Figure 2-4 - Serial IP Screen
5.
In the IP Address field, enter the IP address to
be associated with the SS-100. The network
administrator must determine this IP address
(not a host name). If this information is not
entered, you cannot proceed.
6.
Enter the subnet mask. Again, the network
administrator must provide this information.
7.
The network administrator can determine
whether the remaining fields relating to DNS
and Gateway are required. If they are not, en-
sure that an address consisting of all zeros has
been entered as follows.
0.0.0.0
2.2.

Setting up for Alarm Dialout

Figure 2-5
1.
Log into the Einstein and select
t o edit Alarm Status/Setup.
SS-100 Serial Server
The information must be of the form:
where ppp.ppp.ppp.ppp represents the IP address of the
UltraSite PC.
For example, if the UltraSite PC IP address were:
you would enter 192.168.1.99:3001T in the Phone
field.
The remainder of alarm dialout works as before. As is
the case with the modem, if UltraSite has initiated a con-
nection to Einstein through the network, new alarms will
not be dialed out over the network. This does not mean that
UltraSite will not end up finding new alarms. Once Ultra-
Site terminates the connection, the Einstein alarm dialout
subsystem will reinitiate the connection and retransmit new
alarms.
2.3.
(
,
, and
Installing the SS-100 for Einstein Controllers • 9
2.
Select option
, Dial-out Setup.
3.
Go to the "Day" dial-out configuration screen
"
by pressing
.
4.
With the cursor in one of the three "Type"
'
fields, press
( LOOK UP) and select Se-
rial IP (#5).
<
5.
Press
t wice and then arrow over to the
phone field.
6.
Clear out the Phone field by pressing
enter the address and port information of the
UltraSite PC waiting for alarms.
ppp.ppp.ppp.ppp: 3001T,
192.168.1.99,

Configuring UltraSite

1.
Select Edit Communications Information
from the site pop-up menu to bring up the
Configuration menu.
2.
In the Connection control group, select the
Network/Serial Gateway option.
3.
In the Network Settings control group, fill in
the Address field with the IP address of the
SS-100 device.
?
a nd