Allmatic SCOR.AS Manual - Página 3
Navegue en línea o descargue pdf Manual para Unidad de control Allmatic SCOR.AS. Allmatic SCOR.AS 8 páginas. For barriers bevk 1 motor 24vcc
Imprimir página
6. Setting the wing stroke
This procedure must ONLY be carried out by the installer and ONLY during the put in function of the system. If a transmitter is not used, it is
necessary to use the red key (P1) present on the card or with the P.P. buttons.
The system automatically stops on the mechanical stop or on the limit switch.
Close the automation, see point 4 to move manually the automation
Setting of the course of the wings
Dipswitch Position
1
Press and release the 1° memorized key or
2
the RED (P1) key
Once the automation reaches the position of
3
completely open it recluses automatically
Once the gate reaches the position of
4
completely closed the flashing light blinks 4
times
Dipswitch Position
5
7. Adjusting threshold of the ampere sensor operating
This procedure must ONLY be carried out by the installer and ONLY during the put in function of the system. For a correct programming, before
carrying out the modifications, bring always back the door to the totally closed position.
Repeat the measure
of the torque
With the automation in movement check,
through a dynamometer, the pushing
force.
Repeat the measure
of the torque
WARNING: The adjustments must be carried out so that it is possible to declare the conformity according to the Machine
Directive 98\37\CE and particularly to the EN 12445; EN 12453 ed EN 12635 regulation and successive modifications.
8. Adjusting threshold of the ampere sensor in slowing down
This procedure must ONLY be carried out by the installer and ONLY during the put in function of the system. For a correct programming, before
carrying out any modification, bring always back the door to the totally closed position. If an amperometric intervention occurs near the mechanical
stop the control unit will consider this point as final position and will not invert the movement.
Repeat the measure
of the torque
With the automation in movement
check, through a dynamometer,
the pushing force.
Repeat the measure
of the torque
WARNING: The adjustments must be carried out so that it is possible to declare the conformity according to the Machine
Directive 98\37\CE and particularly to the EN 12445; EN 12453 ed EN 12635 regulation and successive modifications.
6-1622381
rev.2
04/02/2016
The flashing light starts
to blink slowly
The automation
starts to open
The gate closes itself
The learning has had a successful conclusion.
The learning is finished.
The control unit is ready to regularly work.
It is possible to turn the RUNNING AMP.
SENSE trimmer in clockwise sense to
increase the threshold of the ampere
sensor.
The edge of the ampere sense
is too low.
The edge of the ampere sensor
is too high.
It is possible to turn the
AMP.SENS. trimmer in anti – clockwise
sense to lower the threshold of the
ampere sensor.
It is possible to turn the SLOW.DOWN.SENS. in
clockwise sense to increase the ampere sense
threshold of the ampere sensor.
The edge of the ampere sense
is too low
The edge of the ampere sensor
is too high
It is possible to turn the SLOW.DOWN.SENS.
trimmer in anti – clockwise sense to lower the
threshold of the ampere sensor.
ITA
ENG
FRA
ESP
DEU
RUNNING
POR
RUNNING
AMP.SENS
RUNNING
AMP.SENS
SLOW.DOWN.
AMP.SENS
SLOW.DOWN.
AMP.SENS
Pag 3 di 8