HP ProCurve 1600M Manual de instalación - Página 12

Installing the Module

3. Install the Module

1. Use a Torx T-10 or flat-bladed screwdriver to unscrew the screws in the

module slot cover plate in the back of the Switch 2424M. Then remove the

cover plate and store it for possible future use.

2. Hold the module by its bulkhead, taking care not to touch the metal

connectors or components on the board. Orient the module as shown in

the illustration below.

3. Rotate the lever handle fully outward, and then insert the module into the

slot guides and slide it into the slot until it stops.

rotate the handle fully

outward before

installing the module

4. Make sure the two retaining screws are aligned with the holes in the switch,

then rotate the lever handle inward as far as it will go to pull the module

into the switch connectors. The module bulkhead should be in contact with

the face of the switch.

rotate the handle

fully inward

slot guides