HP ProCurve 1600M Instalación y retirada

HP ProCurve 8-Port Power Supply Clip

Installation and Removal

HP ProCurve 8-Port Power Supply Clip (5184-5887) is supported for use on the following switches:

HP ProCurve 2615-8-PoE Switch (J9565A)

■

HP ProCurve 2915-8G-PoE Switch (J9562A)

■

N o te

Prior to installing or removing the Power Supply clip assembly, be sure the power adapter and all cables

have been disconnected and removed.

Installation

Align the clip with the switch

in the orientation shown.

First, insert two alignment

pins on one side of the clip into

the appropriate holes on the

switch (A).

3. Then, align the two

thumbscrews on the other side

of the clip (B), and secure the

clip onto the switch (C).

C A U T I O N :

Use caution when tightening the thumbscrews to the switch. Using excessive force may damage the thumbscrew

or hole threads.

4. Slide the power adapter into the

retention clip from the side as illustrated.

C A U T I O N :

Do not install or remove the adapter

by lifting the clip and forcing the

adapter directly into, or out of, the

housing area.

The information contained herein is subject to change without notice.

The only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing

herein should be construed as constituting an additional warranty. HP will

not be liable for technical or editorial errors or omissions contained herein.

Printed in China

March 2010

Manual Part Number: 5998-0408

*5998-0408*