HP ProCurve 1600M Suplemento del manual - Página 11

USING THE WEB MANAGEMENT INTERFACE

To enable VRRP on a router:

Select the System link from the main menu to display the panel shown in "Configuring a Virtual Router" on

page 11.

Enable VRRP on the System configuration sheet.

Select the Apply button to assign the changes.

NOTE: All VRRP configurations are implemented using a single configuration panel of the Web management

interface.

Configuring a Virtual Router

The command examples in this section show how to configure the routers in Figure 2.

USING THE CLI

Configuring Router1 Using the CLI

To configure VRRP Router1 in Figure 2 after you enable VRRP, enter the following commands:

Router1(config)# inter e 1/6

Router1(config-if-1/6)# ip vrrp vrid 1

Router1(config-if-1/6-vrid-1)# owner track-priority 20

Router1(config-if-1/6-vrid-1)# track-port ethernet 2/4

Router1(config-if-1/6-vrid-1)# ip-address 192.53.5.1

Router1(config-if-1/6-vrid-1)# activate

NOTE: When you configure the Master (owner), the address you enter with the ip-address command must

already be configured on the interface.

The ip vrrp owner command specifies that this router owns the IP address you are associating with the VRID.

Because this router owns the IP address, this router is the default Master router and its VRRP priority is thus 255.

Configuring VRRP