Crescendo Fitness 280 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Entrenador elíptico Crescendo Fitness 280. Crescendo Fitness 280 16 páginas. Magnet power elliptical bike

4. Install the Hand Pulse Bar
a. Insert the hand pulse wires (24) from hand pulse bar (20) into the hole on the back of Front
upright frame (14) and then pull them out from the upper hole of Front upright frame (14).
b. Attach the hand pulse bar (20) to the groove of Front upright frame (14) with two pcs of arch
spacers (45), and bolts (93). (Refer figure 4)
5. Install the Computer
Insert the Pulse wires (24) and Computer wire(26) to the holes on the back of the Computer (10).
Attach the Computer (10) to the top of the Front upright frame (14). (Refer figure 5)
6. Install the Handlebar Support (Right & Left)
a. Attach one Arc spacers (9) and Wave washer (47) to
the right end of horizontal axle of Front upright frame
(14).
b. Insert right Handlebar support (6R) to the right end of
horizontal axle of Front upright frame (14) and secure
it with one Plastic flat washer (53), Big washer (49),
spring washer (51), Special washer (16), and Bolt
(36).
c. After assembled the Nut cap (7) to the Bolt (36), the
right Handlebar support (6R) can move freely.
d. Do the same steps as the above to assemble the left
Handlebar support (6L). (Refer figure 6)
7. Install the Pedal Support Tube (Left & Right)
Insert the left Pedal support tube (4) through the Rear
U-shape bracket (35), a Wave washer (28) and Pedal
axis bushing (54) into the Left pedal axis (30). And then
attach the pedal axis (30) to the crank (67) and tighten them with Power support pole (98) and
then lock the left lock nut (43).
Do the same steps as above to assemble the right Pedal support tube (4) to the right pedal axis
9