Crescendo Fitness 280 Kullanıcı El Kitabı - Sayfa 10

Eliptik Eğitmen Crescendo Fitness 280 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Crescendo Fitness 280 16 sayfaları. Magnet power elliptical bike

Sayfayı Yazdır

4. Install the Hand Pulse Bar

a. Insert the hand pulse wires (24) from hand pulse bar (20) into the hole on the back of Front

upright frame (14) and then pull them out from the upper hole of Front upright frame (14).

b. Attach the hand pulse bar (20) to the groove of Front upright frame (14) with two pcs of arch

spacers (45), and bolts (93). (Refer figure 4)

5. Install the Computer

Insert the Pulse wires (24) and Computer wire(26) to the holes on the back of the Computer (10).

Attach the Computer (10) to the top of the Front upright frame (14). (Refer figure 5)

6. Install the Handlebar Support (Right & Left)

a. Attach one Arc spacers (9) and Wave washer (47) to

the right end of horizontal axle of Front upright frame

(14).

b. Insert right Handlebar support (6R) to the right end of

horizontal axle of Front upright frame (14) and secure

it with one Plastic flat washer (53), Big washer (49),

spring washer (51), Special washer (16), and Bolt

(36).

c. After assembled the Nut cap (7) to the Bolt (36), the

right Handlebar support (6R) can move freely.

d. Do the same steps as the above to assemble the left

Handlebar support (6L). (Refer figure 6)

7. Install the Pedal Support Tube (Left & Right)

Insert the left Pedal support tube (4) through the Rear

U-shape bracket (35), a Wave washer (28) and Pedal

axis bushing (54) into the Left pedal axis (30). And then

attach the pedal axis (30) to the crank (67) and tighten them with Power support pole (98) and

then lock the left lock nut (43).

Do the same steps as above to assemble the right Pedal support tube (4) to the right pedal axis