Cisco C-series Nexus 5020 Manual de instalación del hardware - Página 6
Navegue en línea o descargue pdf Manual de instalación del hardware para Interruptor Cisco C-series Nexus 5020. Cisco C-series Nexus 5020 19 páginas. Replacing an i/o module nexus 5000 series
También para Cisco C-series Nexus 5020: Especificaciones (3 páginas), Ficha de datos (23 páginas), Nota de publicación (26 páginas), Nota de publicación (3 páginas), Manual (11 páginas)
Imprimir página
Replacing Expansion Modules
Installing an Expansion Module in a Cisco Nexus 5500 Platform Chassis
To install an expansion module in a Cisco Nexus 5500 Platform switch chassis, follow these steps:
For the Layer 3 GEMs (N55-M160L3 and N55-M160L3-V2) in the Cisco Nexus 5596UP switch, you
Step 1
must power down the switch first. These expansion modules are not hot swappable.
Remove the module from its packing materials and place it on an antistatic surface.
Step 2
If the captive screw on the expansion module is not loose, turn it counterclockwise to fully loosen.
Step 3
Rotate the ejector lever away from the front of the module until it stops at about 80 degrees from the
Step 4
front.
Holding the module with one hand on the front of the module and the other hand on its carrier edges or
Step 5
bottom, align the module to the open slot.
Push the module fully into the slot until the ejector engages and the lever moves.
Step 6
Rotate the ejector lever to the front of the module so that the module is fully inserted in the slot and the
Step 7
captive screw on the ejector assembly is in position to screw into the expansion module.
Tighten the captive screw to the expansion module.
Step 8
Verify the installation by making sure that the module status LED turns on and is green.
Step 9
Figure 4-5
Figure 4-5
Removing an Expansion Module from a Cisco Nexus 5000 Platform Chassis
To remove an expansion module from a Cisco Nexus 5000 Platform chassis, follow these steps:
Power off the expansion module by using the poweroff module command in global configuration mode.
Step 1
Cisco Nexus 5000 Series Hardware Installation Guide
4-6
shows the positioning of an expansion module in the Cisco Nexus 5548 switch chassis.
Positioning the Module in the Cisco Nexus 5548 Chassis
Chapter 4
Replacing Components