Cisco C-series Nexus 5020 Panduan Pemasangan Perangkat Keras - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Beralih Cisco C-series Nexus 5020. Cisco C-series Nexus 5020 19 halaman. Replacing an i/o module nexus 5000 series
Juga untuk Cisco C-series Nexus 5020: Spesifikasi (3 halaman), Lembar data (23 halaman), Catatan Rilis (26 halaman), Catatan Rilis (3 halaman), Manual (11 halaman)
Halaman Cetak
Replacing Expansion Modules
Installing an Expansion Module in a Cisco Nexus 5500 Platform Chassis
To install an expansion module in a Cisco Nexus 5500 Platform switch chassis, follow these steps:
For the Layer 3 GEMs (N55-M160L3 and N55-M160L3-V2) in the Cisco Nexus 5596UP switch, you
Step 1
must power down the switch first. These expansion modules are not hot swappable.
Remove the module from its packing materials and place it on an antistatic surface.
Step 2
If the captive screw on the expansion module is not loose, turn it counterclockwise to fully loosen.
Step 3
Rotate the ejector lever away from the front of the module until it stops at about 80 degrees from the
Step 4
front.
Holding the module with one hand on the front of the module and the other hand on its carrier edges or
Step 5
bottom, align the module to the open slot.
Push the module fully into the slot until the ejector engages and the lever moves.
Step 6
Rotate the ejector lever to the front of the module so that the module is fully inserted in the slot and the
Step 7
captive screw on the ejector assembly is in position to screw into the expansion module.
Tighten the captive screw to the expansion module.
Step 8
Verify the installation by making sure that the module status LED turns on and is green.
Step 9
Figure 4-5
Figure 4-5
Removing an Expansion Module from a Cisco Nexus 5000 Platform Chassis
To remove an expansion module from a Cisco Nexus 5000 Platform chassis, follow these steps:
Power off the expansion module by using the poweroff module command in global configuration mode.
Step 1
Cisco Nexus 5000 Series Hardware Installation Guide
4-6
shows the positioning of an expansion module in the Cisco Nexus 5548 switch chassis.
Positioning the Module in the Cisco Nexus 5548 Chassis
Chapter 4
Replacing Components