Cisco C-series Nexus 5020 하드웨어 설치 매뉴얼 - 페이지 6

{카테고리_이름} Cisco C-series Nexus 5020에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C-series Nexus 5020 19 페이지. Replacing an i/o module nexus 5000 series
Cisco C-series Nexus 5020에 대해서도 마찬가지입니다: 사양 (3 페이지), 데이터시트 (23 페이지), 릴리스 노트 (26 페이지), 릴리스 노트 (3 페이지), 매뉴얼 (11 페이지)

페이지 인쇄

1. Removing an I/O Module

Replacing Expansion Modules

Installing an Expansion Module in a Cisco Nexus 5500 Platform Chassis

To install an expansion module in a Cisco Nexus 5500 Platform switch chassis, follow these steps:

For the Layer 3 GEMs (N55-M160L3 and N55-M160L3-V2) in the Cisco Nexus 5596UP switch, you

Step 1

must power down the switch first. These expansion modules are not hot swappable.

Remove the module from its packing materials and place it on an antistatic surface.

Step 2

If the captive screw on the expansion module is not loose, turn it counterclockwise to fully loosen.

Step 3

Rotate the ejector lever away from the front of the module until it stops at about 80 degrees from the

Step 4

front.

Holding the module with one hand on the front of the module and the other hand on its carrier edges or

Step 5

bottom, align the module to the open slot.

Push the module fully into the slot until the ejector engages and the lever moves.

Step 6

Rotate the ejector lever to the front of the module so that the module is fully inserted in the slot and the

Step 7

captive screw on the ejector assembly is in position to screw into the expansion module.

Tighten the captive screw to the expansion module.

Step 8

Verify the installation by making sure that the module status LED turns on and is green.

Step 9

Figure 4-5

Removing an Expansion Module from a Cisco Nexus 5000 Platform Chassis

To remove an expansion module from a Cisco Nexus 5000 Platform chassis, follow these steps:

Power off the expansion module by using the poweroff module command in global configuration mode.

Step 1

Cisco Nexus 5000 Series Hardware Installation Guide

4-6

shows the positioning of an expansion module in the Cisco Nexus 5548 switch chassis.

Positioning the Module in the Cisco Nexus 5548 Chassis

Chapter 4

Replacing Components