Siemens SIMATIC NET Manual de instalación - Página 20

Navegue en línea o descargue pdf Manual de instalación para Equipamiento industrial Siemens SIMATIC NET. Siemens SIMATIC NET 40 páginas. Network components bus terminal
También para Siemens SIMATIC NET: Manual de instrucciones (29 páginas), Manual de instrucciones (50 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones de montaje (6 páginas), Información sobre el producto (6 páginas), Manual de instalación (50 páginas), Manual de instalación (40 páginas), Manual de referencia (14 páginas), Manual de instalación (34 páginas), Manual de instalación (48 páginas), Manual de instrucciones (32 páginas)

2.1.3

Mounting the Device to a Panel

To mount the device to a panel, do the following:

2.2

The failsafe relay can be configured to latch based on alarm conditions. The NO

(Normally Open) contact is closed when the unit is powered and there are no active

alarms. If the device is not powered or if an active alarm is configured, the relay

opens the NO contact and closes the NC (Normally Closed) contact.

Note

Control of the failsafe relay output is configurable through RUGGEDCOM ROS . One

common application for this relay is to signal an alarm if a power failure occurs. For

RUGGEDCOM RS8000T

Installation Manual, 01/2021, C79000-G8976-1023-05

Place the device against the panel and align the adapters with the mounting

holes.

Screw

Panel/DIN Rail Adaptor

Figure 2.4

Panel Mounting

Install the supplied screws to secure the adapters to the panel.

Installing the Device

2.1.3 Mounting the Device to a Panel