Siemens SIMATIC NET 설치 매뉴얼 - 페이지 20

{카테고리_이름} Siemens SIMATIC NET에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC NET 40 페이지. Network components bus terminal
Siemens SIMATIC NET에 대해서도 마찬가지입니다: 사용 설명서 (29 페이지), 사용 설명서 (50 페이지), 사용 설명서 (28 페이지), 조립 지침 매뉴얼 (6 페이지), 제품 정보 (6 페이지), 설치 매뉴얼 (50 페이지), 설치 매뉴얼 (40 페이지), 참조 매뉴얼 (14 페이지), 설치 매뉴얼 (34 페이지), 설치 매뉴얼 (48 페이지), 사용 설명서 (32 페이지)

2.1.3

Mounting the Device to a Panel

To mount the device to a panel, do the following:

2.2

The failsafe relay can be configured to latch based on alarm conditions. The NO

(Normally Open) contact is closed when the unit is powered and there are no active

alarms. If the device is not powered or if an active alarm is configured, the relay

opens the NO contact and closes the NC (Normally Closed) contact.

Note

Control of the failsafe relay output is configurable through RUGGEDCOM ROS . One

common application for this relay is to signal an alarm if a power failure occurs. For

RUGGEDCOM RS8000T

Installation Manual, 01/2021, C79000-G8976-1023-05

Place the device against the panel and align the adapters with the mounting

holes.

Screw

Panel/DIN Rail Adaptor

Figure 2.4

Panel Mounting

Install the supplied screws to secure the adapters to the panel.

Installing the Device

2.1.3 Mounting the Device to a Panel