Siemens SIMATIC NET Manuel d'installation - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Siemens SIMATIC NET. Siemens SIMATIC NET 40 pages. Network components bus terminal
Également pour Siemens SIMATIC NET : Manuel d'utilisation (29 pages), Manuel d'utilisation (50 pages), Manuel d'utilisation (28 pages), Manuel d'instructions de montage (6 pages), Informations sur le produit (6 pages), Manuel d'installation (50 pages), Manuel d'installation (40 pages), Manuel de référence (14 pages), Manuel d'installation (34 pages), Manuel d'installation (48 pages), Manuel d'utilisation (32 pages)

2.1.3

Mounting the Device to a Panel

To mount the device to a panel, do the following:

2.2

The failsafe relay can be configured to latch based on alarm conditions. The NO

(Normally Open) contact is closed when the unit is powered and there are no active

alarms. If the device is not powered or if an active alarm is configured, the relay

opens the NO contact and closes the NC (Normally Closed) contact.

Note

Control of the failsafe relay output is configurable through RUGGEDCOM ROS . One

common application for this relay is to signal an alarm if a power failure occurs. For

RUGGEDCOM RS8000T

Installation Manual, 01/2021, C79000-G8976-1023-05

Place the device against the panel and align the adapters with the mounting

holes.

Screw

Panel/DIN Rail Adaptor

Figure 2.4

Panel Mounting

Install the supplied screws to secure the adapters to the panel.

Installing the Device

2.1.3 Mounting the Device to a Panel