Siemens sitrans Manual de instrucciones - Página 12
Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento industrial Siemens sitrans. Siemens sitrans 20 páginas. Variable frequency drives and instrumentation using variable frequency drives and instrumentation without interference
También para Siemens sitrans: Manual (8 páginas)
Imprimir página
Accessory Mounting
Extension Tab
Screw Sensor into threaded hole of tab,
and fasten onto device being monitored.
Notes:
•
If welding, weld must be a continuous bead. Tacking does not provide
sufficient acoustical coupling.
•
Do not arc weld on equipent connected to a SITRANS AS 100. Remove the
SITRANS AS 100 or disconnect electrically to avoid current flowing through
the sensor.
•
If gluing, use Loctite 326 adhesive, or equivalent. Follow manufacturer's
instructions to ensure proper adhesion.
Temperature Considerations
Warning: Temperature at Sensor must not exceed minimum or
maximum ratings.
Ensure adequate isolation from hot
surfaces by providing additional
spacing.
for standard Temperature
Note:
range model, maximum
temperature is 80 °C.
*maximum range dependent on model.
Page 8
< 80 ºC
>80 ºC
SITRANS AS 100 – INSTRUCTION MANUAL
Mounting Disc
Screw Sensor into disc, after welding or
bonding disc onto device being monitored.
Tab acts as heat sink.
Note: If the flange temperature is 100 °C
and the ambient temperature is 20 °C,
the Sensor temperature at the
electronics is below the maximum
rating.
20 ºC
100 ºC
65 ºC
7ML19985DM02