Epson 7700p - PowerLite XGA LCD Projector Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Proyector Epson 7700p - PowerLite XGA LCD Projector. Epson 7700p - PowerLite XGA LCD Projector 12 páginas. Product support bulletin(s)
También para Epson 7700p - PowerLite XGA LCD Projector: Especificaciones (2 páginas), Manual de comunicaciones (20 páginas), Manual del usuario (1 páginas), Resumen técnico (7 páginas), Manual del usuario (10 páginas), Boletín de asistencia sobre productos (1 páginas)

EPSON PowerLite 7700p Projector

4. If you need to replace the filter, remove it as shown below.

Make sure the projector is on its side as shown (not turned

upside down) to prevent dust from falling inside.

5. To install the new filter, first insert the tabs, then press on

the catch until it clicks in place.

tabs

Replacing the Lamp

The projection lamp typically lasts for about 1500 hours of

use. It is time to replace the lamp when:

The projection image gets darker or starts to deteriorate.

The lamp warning light

The message

LAMP REPLACE

the projector lamp comes on (after about 1400 hours of use).

To maintain projector brightness and image quality, replace

the lamp as soon as possible.

Note: You can check to see how many hours the lamp has been

used through the About menu.

Contact your dealer or call EPSON at (800) 873-7766 in the

United States and Canada for a replacement lamp. Request

part number

ELPLP12

10 - EPSON PowerLite 7700p Projector

is flashing red or orange.

appears on the screen when

Follow these steps to replace the lamp:

1. Turn off the projector and unplug the power cord.

2. Allow the projector to cool down for at least an hour (if it

has been on).

3. Use a screwdriver to loosen the screw on the lamp cover.

(You can't remove the screw from the cover.)

When the screw is loose, slide off the lamp cover.

4. Use a screwdriver to loosen the two screws holding the lamp

in place. (You can't remove these screws.)

5. Lift up the wire handle, as shown, and pull the lamp straight

out. (The plastic flap above the lamp will flex out of the way

as you remove the lamp.)

6. Fully insert the new lamp. (The plastic flap will flex out of

the way.)

Caution: Do not touch the glass portion of the lamp assembly.

7. Once the lamp is fully inserted, tighten its screws.

11/00

handle