Epson 7700p - PowerLite XGA LCD Projector 사용자 설명서 - 페이지 10
{카테고리_이름} Epson 7700p - PowerLite XGA LCD Projector에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 7700p - PowerLite XGA LCD Projector 12 페이지. Product support bulletin(s)
Epson 7700p - PowerLite XGA LCD Projector에 대해서도 마찬가지입니다: 사양 (2 페이지), 커뮤니케이션 매뉴얼 (20 페이지), 사용자 설명서 (1 페이지), 기술 요약 (7 페이지), 사용자 설명서 (10 페이지), 제품 지원 게시판 (1 페이지)
페이지 인쇄
EPSON PowerLite 7700p Projector
4. If you need to replace the filter, remove it as shown below.
Make sure the projector is on its side as shown (not turned
upside down) to prevent dust from falling inside.
5. To install the new filter, first insert the tabs, then press on
the catch until it clicks in place.
tabs
Replacing the Lamp
The projection lamp typically lasts for about 1500 hours of
use. It is time to replace the lamp when:
The projection image gets darker or starts to deteriorate.
The lamp warning light
The message
LAMP REPLACE
the projector lamp comes on (after about 1400 hours of use).
To maintain projector brightness and image quality, replace
the lamp as soon as possible.
Note: You can check to see how many hours the lamp has been
used through the About menu.
Contact your dealer or call EPSON at (800) 873-7766 in the
United States and Canada for a replacement lamp. Request
.
part number
ELPLP12
10 - EPSON PowerLite 7700p Projector
is flashing red or orange.
appears on the screen when
Follow these steps to replace the lamp:
1. Turn off the projector and unplug the power cord.
2. Allow the projector to cool down for at least an hour (if it
has been on).
3. Use a screwdriver to loosen the screw on the lamp cover.
(You can't remove the screw from the cover.)
When the screw is loose, slide off the lamp cover.
4. Use a screwdriver to loosen the two screws holding the lamp
in place. (You can't remove these screws.)
5. Lift up the wire handle, as shown, and pull the lamp straight
out. (The plastic flap above the lamp will flex out of the way
as you remove the lamp.)
6. Fully insert the new lamp. (The plastic flap will flex out of
the way.)
Caution: Do not touch the glass portion of the lamp assembly.
7. Once the lamp is fully inserted, tighten its screws.
11/00
handle