Epson 7700p - PowerLite XGA LCD Projector Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Epson 7700p - PowerLite XGA LCD Projector. Epson 7700p - PowerLite XGA LCD Projector 12 pagina's. Product support bulletin(s)
Ook voor Epson 7700p - PowerLite XGA LCD Projector: Specificaties (2 pagina's), Communicatiehandleiding (20 pagina's), Gebruikershandleiding (1 pagina's), Technisch overzicht (7 pagina's), Gebruikershandleiding (10 pagina's), Product ondersteunings bulletin (1 pagina's)

Pagina afdrukken
Epson 7700p - PowerLite XGA LCD Projector Gebruikershandleiding
EPSON PowerLite 7700p Projector
4. If you need to replace the filter, remove it as shown below.
Make sure the projector is on its side as shown (not turned
upside down) to prevent dust from falling inside.
5. To install the new filter, first insert the tabs, then press on
the catch until it clicks in place.
tabs

Replacing the Lamp

The projection lamp typically lasts for about 1500 hours of
use. It is time to replace the lamp when:
The projection image gets darker or starts to deteriorate.
The lamp warning light
The message
LAMP REPLACE
the projector lamp comes on (after about 1400 hours of use).
To maintain projector brightness and image quality, replace
the lamp as soon as possible.
Note: You can check to see how many hours the lamp has been
used through the About menu.
Contact your dealer or call EPSON at (800) 873-7766 in the
United States and Canada for a replacement lamp. Request
.
part number
ELPLP12
10 - EPSON PowerLite 7700p Projector
is flashing red or orange.
appears on the screen when
Follow these steps to replace the lamp:
1. Turn off the projector and unplug the power cord.
2. Allow the projector to cool down for at least an hour (if it
has been on).
3. Use a screwdriver to loosen the screw on the lamp cover.
(You can't remove the screw from the cover.)
When the screw is loose, slide off the lamp cover.
4. Use a screwdriver to loosen the two screws holding the lamp
in place. (You can't remove these screws.)
5. Lift up the wire handle, as shown, and pull the lamp straight
out. (The plastic flap above the lamp will flex out of the way
as you remove the lamp.)
6. Fully insert the new lamp. (The plastic flap will flex out of
the way.)
Caution: Do not touch the glass portion of the lamp assembly.
7. Once the lamp is fully inserted, tighten its screws.
11/00
handle