Cisco 8945 Manual de administración - Página 3

Navegue en línea o descargue pdf Manual de administración para Teléfono IP Cisco 8945. Cisco 8945 16 páginas. Unified ip standard phone
También para Cisco 8945: Ficha de datos (5 páginas), Manual del usuario (42 páginas), Notas de publicación (16 páginas), Manual del usuario (24 páginas), Inicio rápido (2 páginas), Manual de inicio rápido (4 páginas), Manual del usuario (2 páginas), Manual de inicio rápido (2 páginas), Manual del usuario (8 páginas), Manual del usuario (2 páginas), Manual de consulta rápida (5 páginas), Referencia rápida (2 páginas), Manual del usuario (2 páginas), Manual del usuario (3 páginas), Manual de formación (31 páginas), Características Manual (4 páginas), Vistazo rápido (3 páginas), Manual de referencia (28 páginas), Manual del usuario (20 páginas), Primeros pasos (29 páginas)

Imprimir página

Cisco Unified IP Phone Installation

Verify that autoregistration is enabled and is properly configured in Cisco Unified Communications Manager

Administration before you connect any Cisco IP Phone to the network. For information about enabling and

configuring autoregistration, see the Cisco Unified Communications Manager Administration Guide.

Autoregistration must be enabled in Cisco Unified Communications Manager Administration for TAPS to

function.

Procedure

Step 1

In Cisco Unified Communications Manager Administration, click System > Cisco Unified CM.

Step 2

Select the required server and then select the Autoregister check box.

Step 3

Click Save.

Install Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See

Connections

for Cisco Unified IP Phone 8945.

Note

Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before

using external devices, read

To install a Cisco Unified IP Phone, perform the following tasks.

Procedure

Step 1

Choose the power source for the phone:

• Power over Ethernet (PoE)

• External power supply

See

Phone Power

Step 2

Connect the handset to the Handset port.

Step 3

(Optional) Connect a headset to the Headset port. You can add a headset later if you do not connect one now.

See Headsets.

Step 4

Connect a straight-through Ethernet cable from the switch to the network port labeled Network on the Cisco

Unified IP Phone 8941 and 8945. Each Cisco Unified IP Phone ships with one Ethernet cable in the box.

You can use either Category 3, 5, or 5e cabling for 10Mbps connections, but you must use Category 5 or 5e

for 100 or 1000 Mbps connections.

for the connections for Cisco Unified IP Phone 8941 or

External Devices

Requirementsfor guidelines.

Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP

Phone Connections

for safety and performance information.

Install Cisco Unified IP Phone

Phone

for the connections

and SIP)