Cisco 8945 관리 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 8945에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 8945 16 페이지. Unified ip standard phone
Cisco 8945에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 사용자 설명서 (42 페이지), 릴리스 정보 (16 페이지), 사용자 설명서 (24 페이지), 빠른 시작 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 사용자 설명서 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (8 페이지), 사용자 설명서 (2 페이지), 빠른 참조 매뉴얼 (5 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (2 페이지), 사용자 설명서 (3 페이지), 교육 매뉴얼 (31 페이지), 기능 설명서 (4 페이지), 한눈에 보기 (3 페이지), 참조 매뉴얼 (28 페이지), 사용자 설명서 (20 페이지), 시작하기 (29 페이지)

페이지 인쇄

Cisco Unified IP Phone Installation

Verify that autoregistration is enabled and is properly configured in Cisco Unified Communications Manager

Administration before you connect any Cisco IP Phone to the network. For information about enabling and

configuring autoregistration, see the Cisco Unified Communications Manager Administration Guide.

Autoregistration must be enabled in Cisco Unified Communications Manager Administration for TAPS to

function.

Procedure

Step 1

In Cisco Unified Communications Manager Administration, click System > Cisco Unified CM.

Step 2

Select the required server and then select the Autoregister check box.

Step 3

Click Save.

Install Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See

Connections

for Cisco Unified IP Phone 8945.

Note

Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before

using external devices, read

To install a Cisco Unified IP Phone, perform the following tasks.

Procedure

Step 1

Choose the power source for the phone:

• Power over Ethernet (PoE)

• External power supply

See

Phone Power

Step 2

Connect the handset to the Handset port.

Step 3

(Optional) Connect a headset to the Headset port. You can add a headset later if you do not connect one now.

See Headsets.

Step 4

Connect a straight-through Ethernet cable from the switch to the network port labeled Network on the Cisco

Unified IP Phone 8941 and 8945. Each Cisco Unified IP Phone ships with one Ethernet cable in the box.

You can use either Category 3, 5, or 5e cabling for 10Mbps connections, but you must use Category 5 or 5e

for 100 or 1000 Mbps connections.

for the connections for Cisco Unified IP Phone 8941 or

External Devices

Requirementsfor guidelines.

Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP

Phone Connections

for safety and performance information.

Install Cisco Unified IP Phone

Phone

for the connections

and SIP)