Cisco IAD2430 Series Manual de inicio rápido - Página 25
Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Cisco IAD2430 Series. Cisco IAD2430 Series 34 páginas. Integrated access device
También para Cisco IAD2430 Series: Manual general (13 páginas), Visión general (16 páginas)
Imprimir página
Figure 26
Tightening the Velcro Strap
10
Powering On the Cisco IAD
This section provides the procedure for powering on your Cisco IAD2430 router.
Do not use AC and DC power at the same time. If you do, the unit stops operating, and you must reboot it with
Caution
only a single power source.
Checklist for Power-On
You can power on the Cisco IAD2430 series IADs if it meets these requirements:
• The chassis is securely mounted.
• Power and interface cables are connected.
Power-On Procedure
Perform this procedure to power on your Cisco IAD2430 series IADs and verify that it completes its initialization and self-test.
To power on the Cisco IAD, follow these steps:
Step 1
Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.
Move the Cisco IAD power switch to the ON position (Cisco IAD2430 through Cisco IAD2432 IADs only).
Step 2
The green LED next to the auxiliary (AUX) port should come on and the fan should operate. If this does not happen,
see the power-on procedure in the Cisco IAD2430 Series Integrated Access Device Hardware Installation Guide.
For the Cisco IAD2435 IAD, plug in the external power supply (see Figure 24).
F X S
IA D 2 4 3 5 -
W A N
F a st E th e rn
T 1 /E 1
0 /1
8 F X S
e t
0 /0
25