Cisco IAD2430 Series 빠른 시작 매뉴얼 - 페이지 25

{카테고리_이름} Cisco IAD2430 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IAD2430 Series 34 페이지. Integrated access device
Cisco IAD2430 Series에 대해서도 마찬가지입니다: 개요 매뉴얼 (13 페이지), 개요 (16 페이지)

페이지 인쇄

Figure 26

Tightening the Velcro Strap

Powering On the Cisco IAD

This section provides the procedure for powering on your Cisco IAD2430 router.

Do not use AC and DC power at the same time. If you do, the unit stops operating, and you must reboot it with

Caution

only a single power source.

Checklist for Power-On

You can power on the Cisco IAD2430 series IADs if it meets these requirements:

• The chassis is securely mounted.

• Power and interface cables are connected.

Power-On Procedure

Perform this procedure to power on your Cisco IAD2430 series IADs and verify that it completes its initialization and self-test.

To power on the Cisco IAD, follow these steps:

Step 1

Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.

Move the Cisco IAD power switch to the ON position (Cisco IAD2430 through Cisco IAD2432 IADs only).

Step 2

The green LED next to the auxiliary (AUX) port should come on and the fan should operate. If this does not happen,

see the power-on procedure in the Cisco IAD2430 Series Integrated Access Device Hardware Installation Guide.

For the Cisco IAD2435 IAD, plug in the external power supply (see Figure 24).

F X S

IA D 2 4 3 5 -

W A N

F a st E th e rn

T 1 /E 1

0 /1

8 F X S

e t

0 /0