Cisco ONS 15454 Instale

Navegue en línea o descargue pdf Instale para Servidor Cisco ONS 15454. Cisco ONS 15454 32 páginas. Four-shelf and zero-shelf bay assembly
También para Cisco ONS 15454: Manual de instrucciones de instalación (22 páginas), Instale (32 páginas), Desembalaje e instalación (42 páginas), Desembalaje e instalación (40 páginas)

Imprimir página

Install the Shelf and Backplane Cable

This chapter provides procedures for installing the Cisco ONS 15454. For a summary of the tools and

equipment required for installation, see the

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).

10.

11.

12.

March 2005

NTP-A1 Unpack and Inspect the ONS 15454 Shelf Assembly, page

before continuing with the

NTP-A2 Install the Shelf Assembly, page

assembly in a rack.

NTP-A3 Open and Remove the Front Door, page

equipment before continuing with other procedures.

NTP-A4 Remove the Backplane Covers, page

backplane before continuing with other procedures.

NTP-A5 Install the EIAs, page

This procedure is a prerequisite to the

procedure on page

1-22.

NTP-A6 Install the Power and Ground, page

the

"NTP-A7 Install the Fan-Tray Assembly" procedure on page

NTP-A7 Install the Fan-Tray Assembly, page

assembly in the shelf.

NTP-A119 Install the Alarm Expansion Panel, page

planning to install the Alarm Interface Controller–International (AIC-I) card and want to increase

the number of alarm contacts provided by the AIC-I card.

NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page

this procedure as needed to set up wire-wrap pin connections.

NTP-A120 Install an External Wire-Wrap Panel to the AEP, page

connect an external wire-wrap panel to the alarm expansion panel (AEP).

NTP-A9 Install the Electrical Card Cables on the Backplane, page

if you plan to install electrical card cables.

NTP-A10 Route Electrical Cables, page

continuing with the

"NTP-A11 Install the Rear Cover" procedure on page

"Required Tools and Equipment" section on page

"NTP-A2 Install the Shelf Assembly" procedure on page

1-5—Complete this procedure to install the shelf

1-6—Complete this procedure to access the

1-7—Complete this procedure to access the

1-7—Complete this procedure if you plan to install electrical cards.

"NTP-A9 Install the Electrical Card Cables on the Backplane"

1-9—Complete this procedure before continuing with

1-10—Complete this procedure to install the fan-tray

1-12—Complete this procedure if you are

1-23—Complete this procedure as needed before

C H A P T E R

1-4—Complete this procedure

1-10.

1-15—Complete

1-16—Complete this procedure to

1-22—Complete this procedure

1-23.

Cisco ONS 15454 Procedure Guide, R5.0

1-2.

1-5.

1-1