Cisco ONS 15454 Kurulum

Sunucu Cisco ONS 15454 için çevrimiçi göz atın veya pdf Kurulum indirin. Cisco ONS 15454 32 sayfaları. Four-shelf and zero-shelf bay assembly
Ayrıca Cisco ONS 15454 için: Kurulum Talimatları Kılavuzu (22 sayfalar), Kurulum (32 sayfalar), Paketten Çıkarma ve Kurulum (42 sayfalar), Paketten Çıkarma ve Kurulum (40 sayfalar)

Sayfayı Yazdır

Install the Shelf and Backplane Cable

This chapter provides procedures for installing the Cisco ONS 15454. For a summary of the tools and

equipment required for installation, see the

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).

10.

11.

12.

March 2005

NTP-A1 Unpack and Inspect the ONS 15454 Shelf Assembly, page

before continuing with the

NTP-A2 Install the Shelf Assembly, page

assembly in a rack.

NTP-A3 Open and Remove the Front Door, page

equipment before continuing with other procedures.

NTP-A4 Remove the Backplane Covers, page

backplane before continuing with other procedures.

NTP-A5 Install the EIAs, page

This procedure is a prerequisite to the

procedure on page

1-22.

NTP-A6 Install the Power and Ground, page

the

"NTP-A7 Install the Fan-Tray Assembly" procedure on page

NTP-A7 Install the Fan-Tray Assembly, page

assembly in the shelf.

NTP-A119 Install the Alarm Expansion Panel, page

planning to install the Alarm Interface Controller–International (AIC-I) card and want to increase

the number of alarm contacts provided by the AIC-I card.

NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page

this procedure as needed to set up wire-wrap pin connections.

NTP-A120 Install an External Wire-Wrap Panel to the AEP, page

connect an external wire-wrap panel to the alarm expansion panel (AEP).

NTP-A9 Install the Electrical Card Cables on the Backplane, page

if you plan to install electrical card cables.

NTP-A10 Route Electrical Cables, page

continuing with the

"NTP-A11 Install the Rear Cover" procedure on page

"Required Tools and Equipment" section on page

"NTP-A2 Install the Shelf Assembly" procedure on page

1-5—Complete this procedure to install the shelf

1-6—Complete this procedure to access the

1-7—Complete this procedure to access the

1-7—Complete this procedure if you plan to install electrical cards.

"NTP-A9 Install the Electrical Card Cables on the Backplane"

1-9—Complete this procedure before continuing with

1-10—Complete this procedure to install the fan-tray

1-12—Complete this procedure if you are

1-23—Complete this procedure as needed before

C H A P T E R

1-4—Complete this procedure

1-10.

1-15—Complete

1-16—Complete this procedure to

1-22—Complete this procedure

1-23.

Cisco ONS 15454 Procedure Guide, R5.0

1-2.

1-5.

1-1