Epson TM-L90 series Manual de fabricación - Página 9

Navegue en línea o descargue pdf Manual de fabricación para Accesorios para impresoras Epson TM-L90 series. Epson TM-L90 series 22 páginas. Attaching cover on the power switch
También para Epson TM-L90 series: Folleto (1 páginas), Folleto (2 páginas), Manual del producto (27 páginas), Especificaciones (2 páginas), Especificaciones (8 páginas), Manual de información (5 páginas), Especificaciones (4 páginas), Manual del usuario (40 páginas), Manual del usuario (17 páginas), Manual del usuario (21 páginas), Manual del usuario (21 páginas), Empieza aquí (2 páginas), Empieza aquí (2 páginas), Manual (13 páginas), Manual de instrucciones (12 páginas), Manual del usuario (36 páginas), Manual de desarrollo (34 páginas), Manual (2 páginas)

Imprimir página
Epson TM-L90 series Manual de fabricación
Confidential

3.6 Requirements for Die-Cut Label Size

When manufacturing die-cut label paper (with or without black marks), be sure that the paper
meets the following requirements. (The ESC/POS commands expands the settable range,
omitting the margin settings or the limitation on use (NOTE 2 of Section 3.6).)
Corner R2 or less
L
3
1.5 or more
1.75 ± 0.5
1.5 or more
NOTES: 1. Be sure to set the cutting position (L
2. Since the position of the print head and the cutter is not contiguous, the printer
operates as follows when the paper is cut:
1 Completes printing
2 Feeds the paper to the cutting position
3 Cuts the paper
4 Feeds the next label in reverse to the print starting position
Depending on the paper setting or the paper size, the tip of the next label may be
fed over the print head in action 2 above, or the paper may be fed incorrectly or
jammed by catching the tip of the next label with the print head in 4.
To avoid this, be sure that the distance from the cutting position to the print
starting position (=L
length must be 25.4 mm {1"}.
If (L
3
may be fed wastefully because action 4 is not performed.
37.5 ± 0.5 ~ 69.5 ± 0.5 or 79.5 ± 0.5
(Label length:
L
4
25.4 ~ 101.6)
Cutting position
(Printable area)
2.8 or more
Face stock (printing face)
Label Size Requirement
–L
) is 3.6 mm {0.14"} or more. And the minimum label
3
4
–L
) is less than 3.6 mm or the label length is less than 25.4 mm, the paper
4
TITLE
TM-L90
Roll Paper
Manufacturing Guide
Label interval L1:
30.4 ~ 106.6
1.75 ± 0.5
2.8 or more
) between labels.
4
SHEET
REVISION
A
= 5 ± 0.5
L
2
Paper feeding
direction
[Units: mm]
NO.
NEXT
SHEET
6
5