Epson TM-L90 series Manuel de fabrication - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de fabrication pour {nom_de_la_catégorie} Epson TM-L90 series. Epson TM-L90 series 22 pages. Attaching cover on the power switch
Également pour Epson TM-L90 series : Brochure (1 pages), Brochure (2 pages), Manuel du produit (27 pages), Spécifications (2 pages), Spécifications (8 pages), Manuel d'information (5 pages), Spécifications (4 pages), Manuel de l'utilisateur (40 pages), Manuel de l'utilisateur (17 pages), Manuel de l'utilisateur (21 pages), Manuel de l'utilisateur (21 pages), Commencer ici (2 pages), Commencer ici (2 pages), Manuel (13 pages), Manuel d'instructions (12 pages), Manuel de l'utilisateur (36 pages), Manuel de développement (34 pages), Manuel (2 pages)

Imprimer la page

Epson TM-L90 series Manuel de fabrication

1. Automatic Paper Layout Setup

Confidential

3.6 Requirements for Die-Cut Label Size

When manufacturing die-cut label paper (with or without black marks), be sure that the paper

meets the following requirements. (The ESC/POS commands expands the settable range,

omitting the margin settings or the limitation on use (NOTE 2 of Section 3.6).)

Corner R2 or less

1.5 or more

1.75 ± 0.5

1.5 or more

NOTES: 1. Be sure to set the cutting position (L

2. Since the position of the print head and the cutter is not contiguous, the printer

operates as follows when the paper is cut:

1 Completes printing

2 Feeds the paper to the cutting position

3 Cuts the paper

4 Feeds the next label in reverse to the print starting position

Depending on the paper setting or the paper size, the tip of the next label may be

fed over the print head in action 2 above, or the paper may be fed incorrectly or

jammed by catching the tip of the next label with the print head in 4.

To avoid this, be sure that the distance from the cutting position to the print

starting position (=L

length must be 25.4 mm {1"}.

If (L

may be fed wastefully because action 4 is not performed.

37.5 ± 0.5 ~ 69.5 ± 0.5 or 79.5 ± 0.5

(Label length:

25.4 ~ 101.6)

Cutting position

(Printable area)

2.8 or more

Face stock (printing face)

Label Size Requirement

–L

) is 3.6 mm {0.14"} or more. And the minimum label

–L

) is less than 3.6 mm or the label length is less than 25.4 mm, the paper

TITLE

TM-L90

Roll Paper

Manufacturing Guide

Label interval L1:

30.4 ~ 106.6

1.75 ± 0.5

2.8 or more

) between labels.

SHEET

REVISION

= 5 ± 0.5

Paper feeding

direction

[Units: mm]

NO.

SHEET