Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Manual de montaje y puesta en marcha - Página 5

Navegue en línea o descargue pdf Manual de montaje y puesta en marcha para Software Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine. Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 14 páginas. Product support bulletin
También para Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine: Folleto y especificaciones (8 páginas), Hoja de especificaciones (8 páginas), Manual de instalación rápida (34 páginas), Información sobre el producto (17 páginas), Referencia rápida (10 páginas), Especificaciones (4 páginas), Boletín de asistencia sobre productos (44 páginas)

Assembling the Printer and Stand

Mounting the printer on the stand

1. Position the stand in front of the printer (K) as

shown.

2. Lock the two casters and extend the two

stabilizer knobs underneath the stand.

3. Lift the printer by the eight hand grips shown

below.

top view

Caution:

Do not attempt to lift the printer with fewer

than four people.

4. Insert the printer into the guide pins on the

stand.

Note:

When you place the printer on the stand, match the

right end square of the printer to the square of the

same part of the stand.

5. Screw the two wing nuts and washers (J) into

the left and right joint holes at the side-inner

of the stand, and tighten them.

6. Release the front casters and the stabilizer

knobs and move the printer to the place of use

(a short distance away). Lock the casters and

extend the stabilizer knobs after moving.