Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 조립 및 설정 매뉴얼 - 페이지 5

{카테고리_이름} Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine에 대한 조립 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 14 페이지. Product support bulletin
Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 사양 시트 (8 페이지), 빠른 설치 매뉴얼 (34 페이지), 제품 정보 (17 페이지), 빠른 참조 (10 페이지), 사양 (4 페이지), 제품 지원 게시판 (44 페이지)

페이지 인쇄
Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 조립 및 설정 매뉴얼

Assembling the Printer and Stand

Mounting the printer on the stand
1. Position the stand in front of the printer (K) as
shown.
2. Lock the two casters and extend the two
stabilizer knobs underneath the stand.
3. Lift the printer by the eight hand grips shown
below.
top view
c
Caution:
Do not attempt to lift the printer with fewer
than four people.
4. Insert the printer into the guide pins on the
stand.
Note:
When you place the printer on the stand, match the
right end square of the printer to the square of the
same part of the stand.
5. Screw the two wing nuts and washers (J) into
the left and right joint holes at the side-inner
of the stand, and tighten them.
J
6. Release the front casters and the stabilizer
knobs and move the printer to the place of use
(a short distance away). Lock the casters and
extend the stabilizer knobs after moving.
J
3