Dinel CLS-23 Manual - Página 8

Navegue en línea o descargue pdf Manual para Accesorios Dinel CLS-23. Dinel CLS-23 20 páginas. Capacitive level sesors
También para Dinel CLS-23: Manual de instrucciones (18 páginas)

Imprimir página

When installing the sensor into the pipe it

is necessary to choose properly internal di-

ameter of the tube to ensure the inner walls

distances from the electrode to min. 5 mm.

In some cases (sticky liquids, liquids with low

dielectric constant) is suitable to mount the

sensor in the knee tube.

Applies to: CLS–23_–10, 11, 12, 20, 21

max.

min.

Fig. 4: Two state regulation by hysteresis setting

WRONG

CORRECT

Fig. 5: Long fitting tubes in side wall mounting

When installing the sensor in vertical position it can be used

for 2-state (LO-HI) level control between the min. and max.

level. The position of the minimum and maximum level can be

changed by setting the sensor. Fluid changes require new set-

tings of the sensor

E – Electrode length in mm

Applies to: CLS–23_–20, 30 (only for electrically non-conductive liquids)

CORRECT

Fig. 3: Mounting in the pipe

Applies to: CLS–23_–21 (for electrically conductive liquids)

WRONG

Sensor installation close to inlet hole, in a narrow

neck or using improper welding flange may result in

malfunction of the sensor.

Suitable welding flanges can be found in the Dinel

assortment, types ON, NN – see Accessories.

CORRECT

Applies to: All variants

CLS–23