Yamaha DM 2000 Version 2 Manual de orientación - Página 3

Navegue en línea o descargue pdf Manual de orientación para Instrumentos musicales Yamaha DM 2000 Version 2. Yamaha DM 2000 Version 2 8 páginas. Version 2
También para Yamaha DM 2000 Version 2: Manual del usuario (44 páginas), Manual de instalación (28 páginas), Manual de instalación (14 páginas), Manual de instalación (22 páginas), Manual de instalación del software (13 páginas), Manual del usuario (1 páginas), Manual complementario (4 páginas), Manual del usuario (37 páginas), Manual de instalación (35 páginas), Manual de redundancia (8 páginas), Manual del usuario (3 páginas), (alemán) Manual de instalación del sistema operativo (13 páginas)

System Setup

≠

1. Press DISPLAY ACCESS / [DIO].

2. Keep pressing this button to locate "Word Clock Select" page.

3a. Set internal sampling rate as needed* OR...

3b. Select word clock input as needed.

4. Verify Fs box indicates "48KHz" and does not flash "UNLOCK".

5. Press DISPLAY ACCESS / [SETUP].

6. Keep pressing this button to locate "Remote Port Setup" page.

7. Place cursor over AD824 box.

8. Press [ENTER].

NOTE: *48KHz is recommended for sound reinforcement (analog I/O).

Input Patching – Channel

≠

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Input Channel Patch" page.

3. Select the channel.

4. Using the data edit wheel select the input.

5. Press [ENTER].

NOTE: For internal effects returns, also patch effects processor outputs to

available input channels in this fashion.

≠ Input

Channel Names

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Input Channel Name" page.

3. Edit long and/or short channel names as needed.

4. Press [ENTER].

NOTE: Turn check box "Name Input Auto Copy" on/off as needed.

Input Patching – Effects

≠

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Effects 3-8 Input Patch" page.

3. Using the data edit wheel select the processor input – usually a post

fader aux send.

4. Press [ENTER].

≠

Output Channel Patching

1. Press LAYER / [MASTER].

2. Press DISPLAY ACCESS / [OUTPUT PATCH].

3. Keep pressing this button to locate "Slot Output Patch" or "OMNI

Output Patch" page as needed.

4. Select the bus fader to patch.

5. Using the data edit wheel assign bus to output connector.

6. Press [ENTER].