Yamaha DM 2000 Version 2 오리엔테이션 매뉴얼 - 페이지 3

{카테고리_이름} Yamaha DM 2000 Version 2에 대한 오리엔테이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DM 2000 Version 2 8 페이지. Version 2
Yamaha DM 2000 Version 2에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (22 페이지), 소프트웨어 설치 매뉴얼 (13 페이지), 소유자 매뉴얼 (1 페이지), 보충 설명서 (4 페이지), 소유자 매뉴얼 (37 페이지), 설정 매뉴얼 (35 페이지), 이중화 매뉴얼 (8 페이지), 소유자 매뉴얼 (3 페이지), (독일어) 운영 체제 설치 매뉴얼 (13 페이지)

System Setup

≠

1. Press DISPLAY ACCESS / [DIO].

2. Keep pressing this button to locate "Word Clock Select" page.

3a. Set internal sampling rate as needed* OR...

3b. Select word clock input as needed.

4. Verify Fs box indicates "48KHz" and does not flash "UNLOCK".

5. Press DISPLAY ACCESS / [SETUP].

6. Keep pressing this button to locate "Remote Port Setup" page.

7. Place cursor over AD824 box.

8. Press [ENTER].

NOTE: *48KHz is recommended for sound reinforcement (analog I/O).

Input Patching – Channel

≠

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Input Channel Patch" page.

3. Select the channel.

4. Using the data edit wheel select the input.

5. Press [ENTER].

NOTE: For internal effects returns, also patch effects processor outputs to

available input channels in this fashion.

≠ Input

Channel Names

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Input Channel Name" page.

3. Edit long and/or short channel names as needed.

4. Press [ENTER].

NOTE: Turn check box "Name Input Auto Copy" on/off as needed.

Input Patching – Effects

≠

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Effects 3-8 Input Patch" page.

3. Using the data edit wheel select the processor input – usually a post

fader aux send.

4. Press [ENTER].

≠

Output Channel Patching

1. Press LAYER / [MASTER].

2. Press DISPLAY ACCESS / [OUTPUT PATCH].

3. Keep pressing this button to locate "Slot Output Patch" or "OMNI

Output Patch" page as needed.

4. Select the bus fader to patch.

5. Using the data edit wheel assign bus to output connector.

6. Press [ENTER].