Yamaha DM 2000 Version 2 오리엔테이션 매뉴얼 - 페이지 4

{카테고리_이름} Yamaha DM 2000 Version 2에 대한 오리엔테이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DM 2000 Version 2 8 페이지. Version 2
Yamaha DM 2000 Version 2에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (22 페이지), 소프트웨어 설치 매뉴얼 (13 페이지), 소유자 매뉴얼 (1 페이지), 보충 설명서 (4 페이지), 소유자 매뉴얼 (37 페이지), 설정 매뉴얼 (35 페이지), 이중화 매뉴얼 (8 페이지), 소유자 매뉴얼 (3 페이지), (독일어) 운영 체제 설치 매뉴얼 (13 페이지)

Output Channel Names

≠

1. Press LAYER / [MASTER].

2. Press DISPLAY ACCESS / [OUTPUT PATCH].

3. Keep pressing this button to locate "Output Channel Name" page.

4. Select output channel to name.

5. Edit long and/or short output channel names as needed.

6. Press [ENTER].

NOTE: Turn check box "Name Input Auto Copy" on/off as needed.

Input Channel Setup

≠

NOTE: Assume the input patch is completed.

Select the Channel

1. Press LAYER key as needed.

2. Select the channel on that layer by touching the fader.

3. If fader touch sensitivity is turned off, press [SEL].

Set Internal Mic Preamp Gain Trim & Phantom Power

1. Press MONITOR / [DISPLAY] to locate "Solo Setup" page.

2. Set SOLO=ENABLE/MODE=RECORDING/LISTEN=PREFADER/

SEL MODE=LAST.

3. Set +48v on/off as needed for condenser microphones.

4. Press DISPLAY ACCESS / [METER] & locate "Channel 1-24" page.

5. Set metering point and peak hold as needed.

6. Press [SOLO] on channel(s) if needed.

7. Adjust channel(s) gain trim for peak input level of about –6dB.

Monitor quality with headphones.

8. With channel(s) [SOLO] off, meter level at fader '0' is as before.

9. Use channel(s) pad only if peak light is on with trim at minimum.

10. Repeat 3 – 9 as needed for 24 inputs.

Set AD824 Remote Mic Preamp Gain Trim & Phantom Power

1. On SELECTED CHANNEL: PHASE/INSERT, press [DISPLAY].

2. Keep pressing this button to locate "AD824 Gain/Phantom" page.

3. Select preamp and channel with cursor.

4. Adjust gain trim as needed with Data Wheel.

5. Set phantom power as needed by pressing [ENTER]

NOTE: This page is hidden if system setup is not done.

Assign Channel to Bus Output

1. Select the channel.

2. On SELECTED CHANNEL / ROUTING, press bus assignments as

needed.