Yamaha DM 2000 Version 2 Oryantasyon Kılavuzu - Sayfa 3

Müzik Enstrümanı Yamaha DM 2000 Version 2 için çevrimiçi göz atın veya pdf Oryantasyon Kılavuzu indirin. Yamaha DM 2000 Version 2 8 sayfaları. Version 2
Ayrıca Yamaha DM 2000 Version 2 için: Kullanıcı El Kitabı (44 sayfalar), Kurulum Kılavuzu (28 sayfalar), Kurulum Kılavuzu (14 sayfalar), Kurulum Kılavuzu (22 sayfalar), Yazılım Kurulum Kılavuzu (13 sayfalar), Kullanıcı El Kitabı (1 sayfalar), Tamamlayıcı Kılavuz (4 sayfalar), Kullanıcı El Kitabı (37 sayfalar), Kurulum Kılavuzu (35 sayfalar), Yedeklilik Kılavuzu (8 sayfalar), Kullanıcı El Kitabı (3 sayfalar), (Almanca) İşletim sistemi kurulum kılavuzu (13 sayfalar)

System Setup

≠

1. Press DISPLAY ACCESS / [DIO].

2. Keep pressing this button to locate "Word Clock Select" page.

3a. Set internal sampling rate as needed* OR...

3b. Select word clock input as needed.

4. Verify Fs box indicates "48KHz" and does not flash "UNLOCK".

5. Press DISPLAY ACCESS / [SETUP].

6. Keep pressing this button to locate "Remote Port Setup" page.

7. Place cursor over AD824 box.

8. Press [ENTER].

NOTE: *48KHz is recommended for sound reinforcement (analog I/O).

Input Patching – Channel

≠

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Input Channel Patch" page.

3. Select the channel.

4. Using the data edit wheel select the input.

5. Press [ENTER].

NOTE: For internal effects returns, also patch effects processor outputs to

available input channels in this fashion.

≠ Input

Channel Names

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Input Channel Name" page.

3. Edit long and/or short channel names as needed.

4. Press [ENTER].

NOTE: Turn check box "Name Input Auto Copy" on/off as needed.

Input Patching – Effects

≠

1. Press DISPLAY ACCESS / [INPUT PATCH].

2. Keep pressing this button to locate "Effects 3-8 Input Patch" page.

3. Using the data edit wheel select the processor input – usually a post

fader aux send.

4. Press [ENTER].

≠

Output Channel Patching

1. Press LAYER / [MASTER].

2. Press DISPLAY ACCESS / [OUTPUT PATCH].

3. Keep pressing this button to locate "Slot Output Patch" or "OMNI

Output Patch" page as needed.

4. Select the bus fader to patch.

5. Using the data edit wheel assign bus to output connector.

6. Press [ENTER].