Alemite 6713-4 Manual de servicio - Página 8

Navegue en línea o descargue pdf Manual de servicio para Bomba de agua Alemite 6713-4. Alemite 6713-4 10 páginas. High-pressure bucket pump

Imprimir página

SER 6713-4

6. Install and seat Gasket (31) into the

bottom of the Body.

7. Install Plug (32) into the Body.

• Tighten the Plug securely.

8. Screw Tube (38) into the Body.

• Do not tighten at this time.

9. Install Stop Washer (37) and Valve

(36) [small diameter first] onto the

Primer Rod.

10. Screw Valve Seat (35) into the

Tube.

• Tighten the components securely.

11. Screw Priming Plunger (34) onto

the Primer Rod.

• Make sure the holes are aligned.

12. Install Cotter Pin (17).

13. Screw Handle (25) into the Body as

required.

14. Install Bleed Valve Screw (26) into

the Body as required.

Check Valve Assembly

15. Install Pressure-Relief Valve Screw

(29) into Bushing (28).

16. Install Retaining Ring (27) that

secures the Valve Screw to the

Bushing.

17. Screw the Pressure-Relief Valve

Screw Assembly into Adapter

Body (24) [port with the drain

hole].

18. Screw Drain Tube (30) into the

Adapter Body.

NOTE: Refer to Figure

2-C for component identi-

fication on procedures

19-25.

19. Install and seat Spring (48), Spacer

(49) [large diameter first], Washer

(45), and Ball (46) into Coupling

Adapter (47).

Revision (2-02)

20. Screw Ball Seat (44) [with Loctite 242] into the Coupling Adapter.

• Tighten the Ball Seat to 200 inch-pounds (22.6 Nm).

21. Install Gasket (43) onto the Coupling Adapter.

22. Install Coupling Adapter (42) into Coupling Nut (41).

Figure 3 Pump Assembly Model 310750-4 - Section View

High-Pressure Bucket Pump

Refer to Figure 2-B Parts List

for Parts Identification

Alemite Corporation