DIS Sensors QG40N Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Interruptor DIS Sensors QG40N. DIS Sensors QG40N 15 páginas. Tilt/acceleration switch (sil1 plc)
También para DIS Sensors QG40N: Manual del usuario (5 páginas), Manual de usuario y seguridad (6 páginas)

Imprimir página

Zero Adjustment

To eliminate mechanical offsets, a zero adjustment can be performed during the 1

power up the zeroing input is sensitive for a zeroing action.

Sequence:

1. Left input unconnected during power up for at least 0.5s

2. Switched/connect input to Gnd for at least 0.5s

3. Left unconnected again

4. Result: The sensor will set the current inclination position as 0°. The actual zeroing point is

where the input changes from Gnd to unconnected.

The maximum zeroing-range is specified in the datasheet. Horizontal mounting sensors have zeroing-

range-limit of ±5°, vertical mounting sensor can be zero-ed over full 360°.

The new 0° value will be stored in non-volatile memory (EEPROM).

Programmable Parameters (Tilt Switch Only)

Each switching output is pre-programmed to have certain parameters, these parameters can also be

changed by the customer with optional QG40N configurator.

DIS SENSORS BV

User Manual - QG40N Tilt/Acceleration Switch (SIL1 PLc) V2.0

Figure 3 - Configuration panel

minute after