DIS Sensors QG40N 사용자 설명서 - 페이지 10

{카테고리_이름} DIS Sensors QG40N에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIS Sensors QG40N 15 페이지. Tilt/acceleration switch (sil1 plc)
DIS Sensors QG40N에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지), 사용자 및 안전 매뉴얼 (6 페이지)

페이지 인쇄

Zero Adjustment

To eliminate mechanical offsets, a zero adjustment can be performed during the 1

power up the zeroing input is sensitive for a zeroing action.

Sequence:

1. Left input unconnected during power up for at least 0.5s

2. Switched/connect input to Gnd for at least 0.5s

3. Left unconnected again

4. Result: The sensor will set the current inclination position as 0°. The actual zeroing point is

where the input changes from Gnd to unconnected.

The maximum zeroing-range is specified in the datasheet. Horizontal mounting sensors have zeroing-

range-limit of ±5°, vertical mounting sensor can be zero-ed over full 360°.

The new 0° value will be stored in non-volatile memory (EEPROM).

Programmable Parameters (Tilt Switch Only)

Each switching output is pre-programmed to have certain parameters, these parameters can also be

changed by the customer with optional QG40N configurator.

DIS SENSORS BV

User Manual - QG40N Tilt/Acceleration Switch (SIL1 PLc) V2.0

Figure 3 - Configuration panel

minute after