3D Creations North American P 51 D Mustang Manual de instrucciones de montaje - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Juguete 3D Creations North American P 51 D Mustang. 3D Creations North American P 51 D Mustang 15 páginas. Paper scale model kit
Imprimir página
slightly warp the fuselage to get the desired fit of the tabs and that is exactly what we
want. Now cut out part #24. Look carefully and you will find a short gray line that runs
lengthwise on the center of the piece. This is where the antenna mast will be mounted
later. While the piece is still flat you need to cut a slot where the line lies now. See figure
5. Now you are ready to mount part #24 to the fuselage. Remember to check the fit
before applying glue to insure proper placement. When the top part of the fuselage is
complete it should not be flat. It should be raised in the center along the full length of the
fuselage see figure 6. If you can draw the sides down like shown in figure 3 the top
should be evenly curved along the length of the entire piece with no wrinkles. Cut out
part #23 the antenna mast. Fold this piece in half and glue the mast portions together. The
mounting tabs are to be folded out at a 90-degree angle. Apply glue to the top of the tabs
and thread the mast through the slot in part #24 from the inside out.
OK, now that we are done with the top of the fuselage lets start on the bottom. First let
me give you a word of warning. This is one of the more difficult
assemblies of the kit so be sure to fit everything up before you glue.
Find part #22 and cut it out remembering to leave the white areas
that are bordered by a black line attached. Make cuts along the four
black lines that run in from the edges of the white tabs. The white
tabs are intended to remain attached to the piece that resembles a
necktie and cut away from the two sidepieces. Don't cut the two
sidepieces completely off. There should be a very small area left that
connects them to the center section. See figure 7. Apply glue to the
white tabs and glue them to the backside of the sidepieces. Attach
each section of tab one at a time starting from the bottom working up
to the top. Take care to cover the white area only. The warping of the parts becomes
increased with each tab. This creates the shape needed to form the bottom of the nose
section. This piece needs to be aligned accurately. Use the color scheme of the aircraft to
tabs and glue into place. Glue the sides to the center section in the same manor as part
#22. Next shape the piece so that the bottom is flat with the sides bent upward
CREASE) at a 90-degree angle to the bottom. Now
fold the top of the air scoop over and glue the tab to
that by lining up on the stars first everything else will
fall into place. A pen is useful when applying this part. Insert it in the fuselage and use it
for something to push against when pressing the piece in place.
mount part #22 to the nose section of the fuselage.
Locate part #25 and cut it out. Like part #22 the white tabs are
to remain attached to the center section of the piece. Two cuts
are to be made on the scoop area. Make those cuts on the color
side of the black line. The white area is not to be removed.
Although they are extremely small they are gluing tabs.
Draw the pieces together just enough to cover the small white
the opposite side. Glue the
completed part to the
fuselage just aft of the
wing mount once again
using the color scheme to
determine the proper
alignment. I have found
(NO
3