3D Systems CUBE Manual del usuario - Página 12
Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D 3D Systems CUBE. 3D Systems CUBE 20 páginas. Replacing the print tip
También para 3D Systems CUBE: Documentación (8 páginas), Lección (15 páginas)
Imprimir página
NOTE: The Auto Level procedure will begin.
3.
Once the Auto Level procedure has completed, select the
Gap. If the print pad is out of range, proceed to the
4.
The printer will begin checking the Z-gap.
NOTE: The printer will perform an automated gap measurement. This may
take a few minutes.
5.
If Auto Gap is successful, select the
Manual Level
checkmark
to continue.
checkmark
to verify the Z-
procedure.